American Dryer Corp. ADH-75 Installation Manual

ADH-75/ADH-120/ADH-170Installation ManualHEPA NOTE: This dryer has not been scrubbed/decontaminated prior to shipping.American Dryer Corporation88 Cur

10 American Dryer Corp. 113247-3ADSH-120 Component Identification Front View ____________________Illus. No. Description1 Microprocessor Control/Keypad

113247- 3 www.amdry.com 11ADSH-120 Component Identification Rear View _____________________Illus. No. Description1 Basket (Drive) Motor Assembly2 Blow

12 American Dryer Corp. 113247-3!NoteThe manufacturer reserves the right to make changes in specifications at any time without notice or obligation.AD

113247- 3 www.amdry.com 13ADSH-170 HEPA Filter Dryer _________________________________________

14 American Dryer Corp. 113247-3ADSH-170 Component Identification Front View ____________________Illus. No. Description1 Microprocessor Control/Keypad

113247- 3 www.amdry.com 15ADSH-170 Component Identification Rear View _____________________Illus. No. Description1 Basket (Drive) Motor Assembly2 Blow

16 American Dryer Corp. 113247-3Installation Procedures _______________Installation should be performed by competent techniciansin accordance with loc

113247- 3 www.amdry.com 17Fresh Air Supply Requirements _______When the dryer is operating, it draws in room air, heats it,passes this air through the

18 American Dryer Corp. 113247-3Exhaust Requirements ________________Exhaust ductwork should be designed and installed by aqualified professional. Im

113247- 3 www.amdry.com 19NOTE 1 Opening must be 2-inches (5.08 cm) larger than the duct (all the wayaround). The duct must be centered within this o

“IMPORTANT NOTE TO PURCHASER”Information must be obtained from your local gas supplier on theinstructions to be followed if the user smells gas. Thes

20 American Dryer Corp. 113247-3!!ImportantADH-75 and ADH-120: No more than 4 dryersshould be connected to 1 main common duct.ADH-170Multiple Dryer Ve

113247- 3 www.amdry.com 21Electrical Information _________________Electrical RequirementsAll electrical connections must be made by a properly license

22 American Dryer Corp. 113247-3ADEH-75 Electric Models OnlyAll electrically heated dryers must be connected to the electricservice shown on the dryer

113247- 3 www.amdry.com 23For 110V ApplicationsSingle-Phase Electrical Lead ConnectionsBlack+PositiveWhite or Red+Neutralor L2Green+Ground!!For added

24 American Dryer Corp. 113247-3Electrically Heated Models OnlyThe electrical input connections are made at the electric ovencontactor located inside

113247- 3 www.amdry.com 25Steam Information ____________________It is your responsibility to have all plumbing connections madeby a qualified professi

26 American Dryer Corp. 113247-3CompressedAir SupplyAir Pressure Normal 80 psi5.51 bar Minimum Supply 70 psi4.82 bar Maximum Supply 90 psi6.21 bar!!Th

113247- 3 www.amdry.com 27The opposite side of each linkage will then be fastened tothe appropriate damper assembly. There are 5 holes oneach damper

28 American Dryer Corp. 113247-3 NOTES ______________________________________________________________________________________________________________

113247- 3 www.amdry.com 29Preparation for Operation/Start-Up ___The following items should be checked before attempting tooperate the dryer:• Read all

IMPORTANTYou must disconnect and lockout the electricsupply and the gas supply or the steam supplybefore any covers or guards are removed fromthe mach

30 American Dryer Corp. 113247-3TIMING LEGENDSPIN TIMEAdjustment Position Number 1 2 3 4 5Time in Seconds* 30 60 90 120 150DWELL (STOP) TIMEAdjustment

113247- 3 www.amdry.com 31Service/Parts Information ____________ServiceService must be performed by a qualified trained technician,service agency, or

32 American Dryer Corp. 113247-3Routine Maintenance _________________CleaningA program and/or schedule should be established forperiodic inspection, c

113247- 3 www.amdry.com 33Procedure for Functional Checkof Replacement Components _________Microprocessor Controller (Computer) BoardPhase 7 Non-Coin

34 American Dryer Corp. 113247-3Manual ResetBurner Hi-Limit Instructions __________Mechanical TimerThis dryer was manufactured with a manual reset bur

113247- 3 www.amdry.com 35 NOTES ____________________________________________________________________________________________________________________

ADC Part No. 113247 3 - 08/15/07 - 5

4 American Dryer Corp. 113247-3Safety Precautions ____________________WarningFor your safety, the information in this manualmust be followed to minimi

113247-3 www.amdry.com 5MAXIMUM CAPACITY (DRY WEIGHT) 75 lb34.02 kgTUMBLER DIAMETER 37”93.98 cmTUMBLER DEPTH 3 6 ”91.44 cmTUMBLER VOLUME 22.4 cu ft63

6 American Dryer Corp. 113247-3ADEH-75 HEPA Filter Dryer __________________________________________

113247- 3 www.amdry.com 7ADH-120 Specifications _____________________________________________Shaded areas are stated in metric equivalents September 2

8 American Dryer Corp. 113247-3ADEH-120 HEPA Filter Dryer _________________________________________________________

113247- 3 www.amdry.com 9ADSH-120 HEPA Filter Dryer _________________________________________________________